High filling capacity putty with two components, based on unsaturated polyester resin.
Easy to apply. The high filling ability. Strongly adheres to a surface. Fills deep grooves on the surface. Forms a flat surface and is easy to sand. Quickly hardens. Do not apply to the acid curing product or on thermoplastic acrylic surfaces.
Reliably used on aluminum and polyester surfaces in furniture repair work, car paint upgrades and similar repair work as a putty in fillings and as checks to eliminate deep surface defects, as well as sanded steel materials.
Surfaces for application should be cleaned from dirt, residues from old paint, rust and grease and not be wet or wetted.Metallic surfaces should be sanded with Sa 2½.
100 grams Sobsan Polyester Filling Putty and 2-3 grams hardener should be thoroughly mixed to obtain a homogeneous consistency.
Ready mix should be used within 4-5 minutes. It should be applied with a thin layer of a spatula.
The primer process can begin after 30 minutes of use on the surface, depending on the thickness of the application and after sanding with suitable emery paper.
Steel P80-150, Galvanized P220-280, Aluminum P180-240 numbered emery paper recommended.
9 m²/kg (When applied with a thickness of 100 microns, it can vary depending on the problems and the absorption of the surface being repaired).
Stored non-falling direct sunlight in unopened original containers for up to 1 years at 5-35 °C temperature. It should be protected from excessive heat and moisture.
S 2 : Keep out of the reach of children.
S 3/7/9 : Keep container tightly closed in a cool, well-ventilated place.
S 24/25 : Avoid contact with skin and eye.
S 29 : Do not empty into drains.
S 46 : If swallowed, seek medical advice immediately and show this container or label.
S 51 : Use only in well-ventilated areas.
The manufacturer company is not responsible for any defects or results if the instructions for use and storage of products are not followed !